Ilumicon and dmx controllers, Settings, Ilumicode connections – ILUMINARC Ilumiline™ Inground Tri-12 IP User Manual
Page 6: Ilumicode connection diagram, Ilumiline inground tri-12 ip optic 25 rgb qrg

Ilumiline Inground Tri-12 IP Optic 25 RGB QRG
6
Ilumicon and
DMX
Controllers
The Ilumiline Inground Tri-12 IP Optic 25 RGB can operate with either an
Ilumicon or a DMX controller. Use the standard DMX connection, as shown
on page 4 (DMX Junction Box Wiring) to connect this product to any of
those controllers. For more information, please refer to the Ilumiline
Inground Tri-12 IP Optic 25 RGB User Manual.
Settings
To configure the Ilumiline Inground Tri-12 IP Optic 25 RGB, use the
Ilumicode addresser
Ilumicode
Connections
The diagram below shows how to connect the Ilumicode to this product.
Note that this connection will control multiple products at the same time, all
having the same DMX address.
To assign individual DMX addresses to each product, you must connect the
Ilumicode unit to each product, individually. You will also have to
disconnect the DMX output of the product being configured if other
products are connected to it.
Ilumicode
Connection
Diagram
ILUMINARC® suggests connecting no more than 20 products in this mode,
keeping the total distance to less than 60 m (197 ft). If not, you may need to
use an optically isolated signal amplifier.