Controllers, Dmx controller, Installation – ILUMINARC Ilumiline™ 21g2 IP User Manual
Page 13
Installation
Ilumiline 21g2 IP Optic WW User Manual Rev. 2
9
If you have not
configured the
DMX starting
address and
DMX mode for each
product, they will all use
their default values. This
means that all products
will operate in unison.
Controllers
The Ilumiline 21g2 IP Optic WW can operate with a standard DMX controller, or the
Ilumicode addresser. The sections below provide information on how to connect these products
to the corresponding controllers. The instructions to operate these products with each of the
above controllers are in the
Operation
chapter of this manual.
DMX Controller
The Ilumiline 21g2 IP Optic WW can work with a standard DMX controller. The channel
assignments will depend on the DMX address assigned to each product (see the
section).
The figure below illustrates how to connect the DMX controller to the Ilumiline 21g2 IP Optic
WW.