Future Automation PDM - Manual (Page 12)

Tr
o
u
b
le
S
h
o
o
ti
n
g
:
Page 11 of 14 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PDM1, 2 & Custom - Projector Drop Mechanism
PDM1 Projector Drop Mechanism - Trouble shooting guide
Having problems? - Check the following:
1. Are all the connections correct?
2. Is the mechanism being operated correctly?
If the mechanism does not operate correctly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. If this is the case, disconnect the
mains power immediately and contact your installer
Symptom Cause Remedy Page
Emergency stop removed Replace emergency stop 9
Remote control or batteries
faulty
Replace batteries or remote 10
Motor or control box faulty
Apply mains power directly, via AC1
on control box
12
Incorrect pin configuration
Terminate 8-pin RJ45 to 568/b pin
configuration
8
Faulty wiring Replace connector or cable 8
Faulty control box Test contact closure on control box 8
Incorrect settings Refer to instructions 9
Incorrect pin configuration
Terminate 6-pin RJ11 to
configuration supplied
9
ASC11 protocol error Amend Protocol 9
Lift not working
Contact closure not working
RS232 not working