Future Automation PICH - Manual (Page 16)

Tr
o
u
b
le
S
h
o
o
ti
n
g
:
Page 15 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PICH - Picture Lift Heavy Mechanism
PICH Picture Lift Heavy Mechanism - Trouble shooting guide
Having problems? - Check the following:
1. Are all the connections correct?
2. Is the mechanism being operated correctly?
If the mechanism does not operate correctly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. If this is the case, disconnect the
mains power immediately and contact your installer
Symptom Cause Remedy Page
Remote control or batteries
faulty
Replace batteries or remote 14
Motor end stops incorrectly
set
Adjust end stop 9
Incorrect pin configuration
Terminate 8-pin RJ45 to 568/b pin
configuration
12
Faulty wiring Replace connector or cable 13
Faulty control box Test contact closure on control box 13
Incorrect settings Refer to instructions 14
Incorrect pin configuration
Terminate 6-pin RJ11 to
configuration supplied
13
ASC11 protocol error Amend Protocol 13
Lift not level Cables over lapping/damaged re-seat cables 11
Lift not working
Contact closure not working
RS232 not working