Datapath VSN490 - Manual (Page 13)

13
Onboard Graphics Adaptor Disabled
If you do not require a control screen, then you should disable the integrated graphics as described below.
Connect a monitor to the onboard graphics device output and enter setup from the boot screen by
pressing as prompted.
In the BIOS setup utility select:
Advanced>System Agent Configuration>Graphics Configuration>Primary Display [PCIE]
If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the
motherboard, slot 1 is located nearest to the CPU.
Use of the Onboard Graphics Adaptor
Onboard Graphics Adaptor used as Control Screen
The VSN490 is shipped with the BIOS configured to boot off the onboard graphics device. This output can
then be used as the control screen for a typical wall configuration.
To set the system to boot on the onboard graphics device (“CPU Graphics”), enter setup from the boot
screen by pressing or F2 as prompted.
In the BIOS setup utility select:
Advanced>System Agent Configuration>Graphics Configuration>Primary Display [CPU Graphics]
Fig.6