beautypg.com

Stop, Waste oil – Dolmar PS-420 User Manual

Page 28

background image

28

STOP

Refuelling

FOLLOW THE SAFETY PRECAUTIONS!

Be careful and cautious when handling fuels.
The engine must be switched off!
Thoroughly clean the area around the caps, to prevent dirt from

getting into the fuel or oil tank.
Unscrew the tank cap (use the universal wrench if necessary,

see illustration) and fill tank with fuel mixture or saw chain oil

up to the bottom edge of the filling neck. Be careful not to spill

fuel or chain oil!
Screw on the tank cap by hand all the way.
After refuelling, clean screw cap, tank and check for

lekages.

Lubricating the chain
During operation there must always be sufficient chain oil in the

chain-oil tank to provide good chain lubrication. At medium oil

feed rate, the oil tank holds enough for one fuel tank’s worth

of operation. During this procedure check whether there is

enough the chain oil in the tank and refill if necessary. Do this

only with the engine turned off! Screw on the tank cap by

hand all the way.

waste oil

NEVER USE WASTE OIL

Waste oil is very dangerous for the environment.
Waste oil contains high amounts of carcinogenic substances.
Residues in waste oil result in a high degree of wear and tear

at the oil pump and the sawing device.
In case of damage caused by using waste oil or unappropriate

chain oil the product guarantee will be null and void.
Your salesman will inform you about the use of chain oil.

AVOID SKIN AND EYE CONTACT

Mineral oil products degrease your skin. If your skin comes in

contact with these substances repeatedly and for an extended

period of time, it will desiccate. Various skin deseases may result.

In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your

eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!

Important note on bio-degradable chain oils

If you are not planning to use the saw again for an ex-

tended period of time, empty the oil tank and put in a

small amount of regular engine oil (SAE 0), and then

run the saw for a time. This is necessary to flush out all

remaining bio-degradable oil from the oil tank, oil-feed

system, chain and guide bar, as many such oils tend to

leave sticky residues over time, which can cause damage

to the oil pump or other parts.

The next time you use the saw, fill the tank with BIOTOP

chain oil again. In case of damage caused by using waste

oil or unappropriate chain oil the product guarantee will be

null and void.
Your salesman will inform you about the use of chain oil.

chain oil

fuel/oil mixture