d&b T10 - Manual (Page 8)

Technical specifications
Fig. 13: T10 frequency response line source,
single cabinet, standard and CUT settings
Fig. 14: T10 frequency response point
source, standard and CUT settings
T10 system data
Frequency response (–5 dB standard).................................................68 Hz ... 18 kHz
Frequency response (–5 dB CUT mode)...........................................120 Hz ... 18 kHz
Max. sound pressure (Line/Arc setups, 1 m, free field)..................................................
with D6........................................................................................................................129 dB
with D12......................................................................................................................132 dB
Max. sound pressure (PS setup, 1 m, free field)..............................................................
with D6........................................................................................................................127 dB
with D12......................................................................................................................130 dB
(SPLmax peak, pink noise test signal with crest factor of 4)
Input level (100 dB-SPL/1 m)...............................................................................–13 dBu
T10 loudspeaker
Nominal impedance...............................................................................................16 ohms
Power handling capacity (RMS / peak 10 ms).........................................200/800 W
Nominal dispersion angle (point source, hor. x vert.)..................................90° x 35°
Nominal dispersion angle (line array, horizontal)..................................................105°
Splay angle settings........................................................................0...15° (1° increment)
Components...................................................2 x 6.5“ driver with neodymium magnet
...................................................1.4” exit compression driver on rotatable waveguide
....................................................................................................Passive crossover network
Connections................................................................................................................2 x EP5
...................................................................................................................Optional: 2 x NL4
Pin assignments.......................................................................................................EP5: 1/2
..............................................................................................................................NL4: 1+/1–
Weight...............................................................................................................11 kg (24 lb)
Fig. 15: T10 cabinet dimensions in mm [inch]
T10 Manual (1.0 EN) Page 8 of 10