d&b 24C - Manual (Page 13)

Tools required
–
Torx wrench / screwdriver size #TX20
– Torx wrench / screwdriver size #TX15
Remarks
The assembly may be carried out by a single person. However, we
recommend a second person for assistance. Proceed as follows:
1. Preparing the 24C cabinet
1. At the rear of the cabinet, undo the two countersunk screws
(torx #T20) for the top panel.
2. Slightly lift the front part of the top panel.
3. Lift the back part of the top panel out of its guiding slot.
4. Disconnect the input connector
[I] and take off the top panel.
2. Preparing the 24C-E cabinet
1. At the rear of the 24C-E cabinet, slacken the eight fixing
screws (set screws - #T15) of the connecting rails.
3. Attaching the 24C-E extender
d&b 24C/24C-E Manual 1.3 en 13