Dynex DX-DPF7 - Manual (Page 3)

Setting up your digital picture frame 3
Remote control
Setting up the remote control
Note : Pull the plastic tab sticking out of the remote control. It protects the
battery. The remote control cannot work unless it is removed.
To install or replace the remote control battery:
1 Hold the remote control with the control buttons facing
downward.
2 While pressing down on the ridged area of the battery cover, pull
the tray out.
3 Remove the old battery, if necessary.
4 Place a CR2025 lithium battery on the tray with the positive + end
facing toward you.
5 Close the tray.
Setting up your digital picture
frame
To set up your digital picture frame:
1 Extend the stand from the back of your digital picture frame.
2 Rotate the stand to position the frame either vertically or
horizontally.
3 Place your digital picture frame on a flat surface.
4 Plug one end of the AC power adapter into your digital picture
frame.
5 Plug the other end of the AC power adapter into a wall outlet.
6 Insert a memory card or USB device into the appropriate slot.
Note : The card only fits in one direction. Do not force it. The card should fit
snugly when correctly inserted.
7 Press the POWER button on the top of your digital picture
frame to turn it on.
Using your digital picture frame
To turn on your frame and select a photo:
1 Press POWER on the top of your digital picture frame, your
frame turns on.
2 Insert a card into one of the card slots or insert a USB memory
device into the USB slot. The photos display automatically.
3 Press EXIT. The Main Menu opens.
4 Press EXIT again to enter the Card Selection screen, then press the
PREV o r NEXT button to select the card you want.
5 Press PLAY/PAUSE/MODE to enter the Slide Show mode. This
displays photos, based on the Transition Mode settings.
6 Press PLAY/PAUSE/MODE again to enter the Browse mode.
Your frame displays a single picture.
7 Press PREV o r NEXT to select a photo.
8 Press PLAY/PAUSE/MODE a third time to enter Thumbnail
mode. The thumbnail images appear on the screen in a table.
9 Press PREV , NEXT , UP , or DOWN to select a
thumbnail, then press PLAY/PAUSE/MODE to show the
picture.
To copy photos to your frame:
1 Press POWER on the top of your digital picture frame, the
frame turns on.
2 If your frame is in slide show mode, press EXIT. The Main Menu
opens. If the Main Menu is already open, go to the next step.
6
DOWN /ROTATE
button
Press to navigate the on-screen menus
or to rotate a photo.
7
PREV button
Press to navigate the on-screen menus
or to view the previous photo.
8
NEXT button
Press to navigate the on-screen menus
or to view the next photo.
# Button Action
1 MENU Press to enter the Setup Menu.
2
PREV
Press to move the cursor to the
left or to access the previous
photo.
3 COPY/DEL. Press to copy a photo into frame
memory or to delete a photo
from the frame.
4 EXIT Press to return to the Main menu
or to enter the card selection
screen when the Main Menu is
displayed.
5 ZOOM Press to enlarge the displayed
photo by 100%, 117%, 133%,
150%, or 200%.
6
UP
Press to move the cursor up.
7 PLAY/PAUSE/MODE Press to confirm a selection,
pause a slide show, or change
modes (Slide Show, Browse,
Thumbnail).
8
NEXT
Press to go to the next photo.
9
DOWN /ROTATE
Press to navigate the on-screen
menus or to rotate a photo.
10 SLIDE SHOW Press to enter Slide Show mode.
# Item Description
10
6 /, '( 6 /, '(
4
6
7
8
9
2
1
3
5
Digital Picture Frame