Crimson HT User Manual
Strap-toggle, Specification & design manual

Wing
AISI 1010
Plating
ASTM B633, SC1, Type III, (Fe/Zn 5)
Anchor Body
Engineered Plastic
Strap-Toggle
TM
SPECIFICATION & DESIGN MANUAL
SECTION CONTENTS
Page No.
General Information ................. 283
Material
............. 283
Installation
........ 283
Performance Data...................... 284
Ordering Information................ 284
Strap-Toggle
ANCHOR MATERIALS
Engineered Plastic
Carbon Steel (Wing)
ANCHOR SIZE RANGE (TYP.)
3/16" to 1/2" diameter
SUITABLE BASE MATERIALS
Wallboard
Hollow Concrete Masonry
Dimension
3/16"
1/4"
3/8"
1/2"
ANSI Drill Bit Size, d
bit
(in.)
*1/2
*1/2
**3/4
**3/4
1
1
8
/
5
8
/
5
).
n
i(
e
z
i
S
p
a
C
2
/
1
2
2
/
1
2
2
/
1
2
2
/
1
2
).
n
i(
e
g
n
a
R
p
ir
G
Thread Size (UNC)
3/16-24
1/4-20
3/8-16
1/2-13
Max.Tightening Torque, T
max
, (ft-lbs)
5
5
5
5
Minimum Clearance (in.)
1 7/8
1 7/8
1 7/8
1 7/8
Anchor Diameter, d
INSTALLATION SPECIFICATIONS
Anchor Component Component Material
Drill the proper size hole
into the cavity of the
hollow base material.
Position the wing parallel
to the plastic legs and slide
the anchor through the
drilled hole into the hollow
cavity.
Pull the wing
against
the inside wall of the
hollow material using the
ring, then slide the plastic
cap forward until the
is seated
against the work surface.
Place your thumb between
the plastic straps and snap
the straps off.
Position the
e. Insert
the bolt through the
and tighten. The minimum
bolt length should be at
least 1/2" longer than the
combined wall and
e.
Installation Guidelines
Strap-Toggle
TM
Hollow Wall Anchor
PRODUCT DESCRIPTION
The Strap-Toggle is a heavy duty hollow wall anchor designed for use in base materials such
as plaster, wallboard, concrete block or hollow tile. The Strap-Toggle is a pre-assembled
anchor consisting of a carbon steel wing and a locking cap/ratchet leg assembly molded
from engineered plastic. It is available in 3/16", 1/4", 3/8" and 1/2" sizes. When compared
to traditional toggles, this unique anchor can be installed in a smaller hole and does not
require a
re or screw to set it. The anchor can be easily adjusted to accommodate a
wall thickness of up to 2 1/2" while using a shorter bolt. The bolt and
re may be installed
and removed as often as necessary.
FEATURES AND BENEFITS
• Adjustable to accommodate various wall thickness up to 2 1/2"
• Allows for
re and bolt/screw removal and re-anchoring
• Federal GSA
– Meets the descriptive requirements of FF-B-588D, Type V
for a captive toggle (superseded)
MATERIAL SPECIFICATIONS
*9/16" diameter bit may be required for very dense materials.
**13/16" diameter bit may be required for very dense materials.