Channel Master Enhanced DVR+ Remote (7500XRC2) - Manual (Page 5)

5
Troubleshooting Programming the Remote Control, continued
Press and hold the SETUP button until the LED blinks
twice.
Press the VOLUME(+) button.
Press the GREEN button. (If you wish to revert volume
control back to your TV, use the TV button in this setup
instead of Audio.
Press and hold the SETUP button until the LED blinks
twice.
Press the INPUT button.
Press the GREEN button. (If you wish to revert input
control back to your TV, use the TV button in this setup
instead of Audio.
1
1
2
2
3
3
Setting the Volume(+)/Volume(-) to adjust audio device
Volume as an alternative to TV volume
Follow this procedure to program the Volume(+) / Volume(-) buttons to operate your
audio device.
Note: Before this can be done, you will first need to program your audio device as
explained on page 3.
Setting the Input Key to adjust audio device Input as an
alternative to TV Input
Follow this procedure to program the Input button to operate your audio device.
Note: Before this can be done, you will first need to program your audio device as
explained on page 3.
Remote | Quick Start Guide