Brennenstuhl Moisture Detector MD - Manual (Page 8)

8
Operating Instructions MD
Check the moisture content of construction
materials
e.g. concrete, tile, screed, plaster, carpets prior to
finishing.
Check the moisture content of wood
e.g. of firewood or wood as a building material
Determining the moisture content of soil
Use the setting for “construction materials”
IMPORTANT NOTICES
Place the probe tips on the surface
carefully, do not apply force.
Handle the device carefully when the protective cap
has been removed. The probes can cause injuries if
used improperly.
When measuring soil, you will get low
readings if the readings are only
taken at the surface and higher
readings the deeper you press the
probes into the soil. The measured
value will differ significantly if you
take readings in loose or tightly
packed flower garden soil.
If the probes are set on a metal or a conductive
surface, the maximum value of >>50<< or >>33<< will
appear in the display.
Keep the probes clean using a damp cloth and put
them back in the protective cap.
Soil Soil
Metal
007709 Feuchtigkeitsdetector MD_007709 BA_Feuchtigkeitsmesser 27.10.14 16:20 Seite 8