Bem Wireless Speaker Trio - Manual (Page 5)

8 9
AUX out
The Speaker Trio can also be used as a "bridge" to wirelessly connect
you devices to other speakers not enabled with Bluetooth©.
Plug one end of the supplied Aux cable to the “AUX OUT” port in the
back of unit and plug the other end of the cable to an “AUX IN” or
"Line In" port on any other speaker system
Please note, volume + & volume - on the Speaker Trio lose function
on this occasion and only the connected Bluetooth© device or the
connected speaker itself can control the volume.
Charging
Connect your Speaker Trio base to an outlet using the included
power adapter. Place the speakers onto the charging area of the
base. The red backlight will slowly flash during charging and goes out
when it has reached a complete charge (Approx. 3.5 hours).
Charging Indicator Light Modes
•
Red LED / Flashing Fast: Battery is low, charge the unit soon.
•
Red LED / Flashing Slow: Speaker Trio is charging
•
Red LED / Turned Off: Battery is fully charged
Note: if the unit has not been used in the past 7 days please charge
for 10 minutes before using the Speaker Trio.
Operation Details
(cont.)
Troubleshooting
Issue: Pairing is unsuccessfully after multiple attempts
Solution:
•
Check if the Bluetooth© indicator light is on. If the indicator
light is off, please press the power button to turn the unit on.
If the Bluetooth©
indicator light still doesn’t come on after
pressing the power button, please charge the unit.
•
Check for other Bluetooth© devices around the surroundings
that may interfere with searching and turn devices off.
•
Power off and then power on the unit to restart the Bluetooth©
function of the unit or your Bluetooth device
•
Unplug any cables plugged into the AUX IN, restart all devices
and then attempt pairing again.
Issue: Interference or static during playback
Solution:
•
Avoid using the device between concrete or other building
structures that may interfere with the signal.
•
Please check if the battery level of the unit and the Bluetooth©
device and charge if necessary.
For more troubleshooting help go to http://bemwireless.com