beautypg.com

AVUE AVC552MIP – 2 Mega Pixel IP Network Bullet Camera User Manual

Page 3

background image

The Alarm Wiring Diagram

Hardware Installation

1. Plug in the power connection to the IP camera.
2. Plug in the IP camera cable.
3. Confirm the correct network connection status (PC/HUB/ IP camera).
4. In the PC IE Browser, key in the camera’s IP online to link up to the live first

page.


NOTE: The user can replace the desiccant pack

depending on how often the camera
interior has been opened to the
environment. Stick and fix a desiccant
pack to the inner side of the camera with
a two-side adhesive tape, then reattach
the cover of the camera.


















WARNING

To prevent fire or shock hazard, avoid exposing this unit to rain or moisture.

Do not block ventilation openings.

Do not place anything on top of the unit that might spill or fall into it.

Do not attempt to service this unit yourself, as opening or removing covers may expose
you to dangerous voltage or other hazards. Please refer all servicing to your distributor /
retailer.

Do not use liquid cleaners or aerosols for cleaning.

To prevent fire or electric shock, do not overload wall outlets or extension cords.

PoE warning : If the PoE injector is used instead of the supplied power adaptor, all of the
wiring to and from the injector must be routed/ installed inside a building/ plant and never
routed/ installed outside of the building/ plant.

Please only select a power adapter or power certified by UL and marked at 24Vac / 60 Hz,
minimum 1A, class 2 or LPS.

The interconnecting cables should be placed inside the UL certified Outdoor Use
Conduits.

If the power supply is installed outdoors, it should be a listed rainproof / watertight class 2 /
LPS power supply or a listed power supply complying with UL60950 -1, part 1 and part 22.

The wiring method should comply with article 725 and article 300 in the national electrical
code for the class 2 circuit and wiring in duct.

The entire installation should be performed by qualified personnel.

Please do not look directly at the shining, reflecting surface of the camera housing.
Looking directly could result in eye uncomfortable.

This product should not be used for the same purposes as consumer electronic devices.

CAUTION

GND

12V+

Di -

Di +

Do -

Do +

+12V

+12V

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF

USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

3 RMN0100560