Atlona AT HD M2C - Manual (Page 4)

DC 5V
HDMI IN FIRMWARE
ANALOG DIGITAL HDMI OUT
RIGHT LEFT
DC 5V
HDMI IN FIRMWARE
ANALOG DIGITAL HDMI OUT
RIGHT LEFT
4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Panel Description
Front Panel
1. HDMI Input port: Connect HDMI source here.
2. Mini USB port: Firmware update port, connect a Mini USB to USB A cable to a computer.
3.
Red Power LED: Illuminates when receiving power.
4. Green Signal LED: will illuminate when a PCM audio signal is detected.
5. Green Signal LED: Lights up when receiving a Dolby ® Digital signal.
6. Green Signal LED: Dolby ® Digital Plus signal indicator.
7. Green Signal LED: Illuminates when receiving a Dolby ® TrueHD signal.
8. Green Signal LED: Light will illuminate when a DTS Digital Surround™ is present.
9. Green Signal LED: Signal light will turn on when DTS-HD Master Audio™ signal is received.
NOTE: LED signifies incoming digital audio signal type only. The HD-M2C does not decode Dolby
or DTS signals. It will down convert and pass 2 channel audio only to all outputs.
1 2 3 4 5 6 7 8 9
Back Panel
1. DC 5V: Connect included locking 5V DC adapter here.
2. L/R audio port: Connect to an amplifier (ex. AT-PA100-G2).
3. Digital audio port: Digital Optical/Coaxial out to connect to an AVR with no HDMI support.
NOTE: Audio output is 2CH only, multichannel audio is not passed through these ports.
4. HDMI out port: Connect to an HDMI display.
1 2 3 4