Atlona AT PA100 G2 User Manual
Page 9
9
Do not use a carriage return at the end of the commands. “.” and “%” terminate the commands.
Note: Factory Default settings, when first turned on, are: volume 50, bass 4, and treble 4.
Note: The AT-PA100-G2 has last memory, so if the power is lost the volume, bass, and treble settings
will remain the same as before the power loss.
Command
Feedback
Description
8xx%
Bass of LINE: xx
Preset the bass level, [xx] arranges from [00] to [08].
Example: 803% --> Bass of LINE: 03
9xx%
Treble of LINE: xx
Preset the treble level, [xx] arranges from [00] to [08].
Example: 905% --> Treble of LINE: 05
Input Ports
2 x RCA connectors
1
x
3.5mm
Audio
1
x
3.5mm
IR
1
x
Captive
Screw
MIC
1
x
Captive
Screw
RS-232
Output Ports
1 x Captive Screw Audio
1
x
3.5mm
Loop
Out
Dimensions (HxWxD)
1.5 x 3.78 x 3.43 (inch)
38 x 96 x 87 (mm)
Weight 0.66lbs
0.3kg
Power
consumption
40W
Audio
Gain:
32dB
Frequency Range:
20Hz to 20KHz
Signal/Noise Ratio:
80dB (at max output)
Total Harmonic Distortion:
1% (1KHz), 0.3% (20KHz) -- at nominal levels
Input Impedance:
Input 1&2: >10KΩ
MIC Input Impedance:
48V: 35KΩ
MIC:
10KΩ
LINE:
75KΩ
Output Impedance:
3.5mm Loop Out: 50Ω stereo
Speaker
out:
4
~
8Ω Amplifier
Stereo Channel Separation:
>75dB from 20Hz to 20KHz
Common Mode Rejection Ratio: >70dB from 20Hz to 20KHz
MIC Audio Detection Delay:
1ms
Specifications
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515