Atlona ATHDVS TX WP - Manual (Page 4)

4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
HDMI IN
VGA IN AUDIO IN
AT-HDVS-TX-WP
INPUT
SELECT
DISPLAY
ON/OFF
LINK
Panel Description
1. DISPLAY ON/OFF button: Controls display through RS-232 when used with compatible receivers
(Ex. AT-HDVS-RX) - Button will illuminate when the display is off
Note: If DISPLAY ON/OFF button is held for 3 seconds the unit will reset
2. LINK LED: Illuminates when receiving power/signal from compatible receivers (ex. AT-HDVS-RX)
3. HDMI IN: Connect HDMI source here
4. INPUT SELECT button: Use to switch between VGA and HDMI source
Button will illuminate blue for HDMI
Button will illuminate red for VGA
5. VGA IN: Connect VGA source here
6. AUDIO IN: Connect analog audio here (for use with VGA input only)
7. RJ45 port: Connect compatible HDBaseT receiver (ex. AT-HDVS-RX) here
3
6 7 6 4
1 2
When switching the product between US and UK face plates, three layers of screws will need to be
removed.
Replace the grey and the white face plates with the correct regional face plate starting at layer 3
until layer one has been replaced.
The first set of screws that need removal are the locking screws for the HDMI and VGA ports. There
are 3 total to remove.
The top white face plate can be removed once those have been taken out.
The second set of screws to remove are in the grey tabs attached to the wall plate back box.
Remove all 4.
The back box can be removed now.
The third set of screws for removal are at the bottom of the PCB boards. Place the grey face plate
down and remove the 4 screws from the corner edges. The grey plate is removable now.
US and UK Face Plate Change
First Layer
Second Layer
Third Layer