Atlona AT 2VGA300SL - Manual (Page 6)

CONNECTION AND INSTALLATION
Blink three times: DDC check sum error
Blink four times: Memory read error
Blink five times: Memory writes error
Blink six times: Memory verify error
AT-2VGA300SL/AT-4VGA300SL Duplicate DDC step:
1. Dip switch 1 & 2 at “down” position, if the Sender already connected to the local monitor; please jump to the third
step.
2. If Sender has not connected with local monitor yet, the yellow LED will keep lit to wait local monitor connection.
3. After few seconds DDC duplication will finish, then yellow LED will be off.
4. If the duplication is successful, the yellow LED will blink one time. If failed, yellow LED will blink several times,
please refer to above “Yellow LED status indication”
5. Please unplug the local monitor after finishing the DDC duplication, and move dip switch 2 at “down”, 1 at “up”,
then start to use DDC data which have beenduplicated.
AT-VGA300RL Remote unit adjustment:
EQ equalization (sharpness)
Gain signal boost (brightness)
AT-VGA300RL LED:
Blue (front panel): power on/off
RJ45 LED (Link cable connector):
Green: power on/off
Caution: The cabling must keep away from any equipment with electromagnetic wave, i.e.:microwave, radio equip-
ment, high voltage lines.
Cable:
Video Link cable using hi quality CAT5E UTP/STP or CAT6 UTP cable. Recommended wiring 568-B
Please note STP cable can enhance noise rejection, as well less transmissionrange and picture sharpness quality.
Connection Diagram:
Total 300M Total 300M
CAT 5 cable
Source
Display
Display
AT-4VGA300SL
AT-2VGA300SL
AT-VGA300RL
AT-VGA300RL
CAT 5 cable
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
5