Atlona AT DIS7 PROHD User Manual

Page 4

3 4 5

1. Output Speakers: These are the two built-in 2Channel speakers.
2. DC 5V: This input is for 5V power supply. If optional battery is used, the power supply is
not required
3. DOWN: Press this button to lower the audio volume. Also controls Menu and EDID
4. HDMI/DVI IN: Source is connected here. If using a DVI source an adapter will be needed.
5. UP: Press this button to raise the audio volume.
6. INPUT: Selects input signal type. Press repeatedly until signal is on correct input
7. POWER & LED: This buttons toggles the AT-DIS7-PROHD on and off.
8. VGA/COMPONENT INPUT: Source is connected here. If using a Component source, use the
included VGA to Component adapter.

The On-screen Display Menu can be moved so that you may have the input source menu and
AT-DIS7-PROHD menu available the same time. Press the up arrow or down arrow to change
the position of the OSD Menu.
Note: Before plugging in the source, change the OSD Menu position. Once an input is
plugged in the arrow buttons will only change volume.

The AT-DIS7-PROHD has the ability to copy the EDID of any display. Press the up and down
arrows simultaneously to start copying. “Check DDC...” will appear on the display screen
while in process. Once done you will see either a red (indicates the copy failed) or green
(indicates the copy was successful) message.
Note: There is no last memory. If power is lost from unplugging, pressing the power button,
or in any other way the copied EDID and OSD Menu will reset to factory settings.

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

Panel Description

OSD Menu

EDID Learning