DeWalt D26411 - Manual (Page 9)

7
English
OPERATION
WARNING: Make sure the nozzle ALWAYS points away from
you and any bystanders.
WARNING: DO NOT drop anything into the nozzle.
WARNING: Use only one hand to hold the tool as shown in
Figure 2. Do not place your other hand over the air vents (Fig. 3).
FIG. 2 FIG. 3
PRIOR TO OPERATION
1. Attach the correct accessory recommended for the application.
2. Turn the air temperature adjustment knob (D) to desired air
temperature.
Switching On and Off (Fig. 4)
1. Push the on/off switch (A) to the desired air flow settings:
I:240 liter/min [122–752ºF (50˚C-400˚C)]
A low air flow to heat up the workpiece slowly.
II:450 liter/min [122–1112ºF (50˚C-600˚C)]
A high air flow to heat up the workpiece quickly.
2. To turn the tool off, push the on/off switch (A) to position O.
Disconnect the tool from the power source and let the tool cool
down before moving or storing it.
A
FIG. 4
Stripping paint
WARNING: Refer to Important Notice under Additional Safety
Instructions for Heat Guns before using the tool remove paint.
WARNING: Do not strip metal window frames as the heat may
crack the glass.
• When striping other window frames, use the glass protection
nozzle.
• To prevent igniting the surface, do not keep the tool directed
at one spot too long.
• Avoid collecting paint on the scraper accessory, as it may
ignite. If necessary, carefully remove paint debris from the
scraper accessory using a knife.
1. Attach the appropriate accessory.
2. Turn the air temperature adjustment knob (D) to high.
3. Turn the tool on by selecting the desired air flow.
4. Direct the hot air onto the paint to be removed.
Best results will be achieved if the heat gun is moved slowly, but
CONSTANTLY, from side to side to evenly distribute heat. DO
NOT LINGER OR PAUSE IN ONE SPOT.