American Weigh Scales (AWS) MSC-500 - Manual (Page 4)

obtain just the weight of the contents.
5. When the container is removed, a negative number
will be displayed. Press [ ] again to zero the scale.
IV. CALIBRATION
This scale has come pre-calibrated at the factory. Only
re-calibrate if you are experiencing trouble weighing.
MSC-100 uses a 100g calibration weight
MSC-500 uses a 500g calibration weight
A. MSC-100 Calibration:
1. Turn the scale OFF.
2. While holding the [ M ] key, tap the [ ] key to turn
the scale on then release both keys.
3. The display will show a random number, press the
[ M ] key again.
4. The display will flash “100.00”. Place the required
weight on the platform and wait for 3 seconds.
5. The display will show “PASS” and “100.00”. Remove
the weight and press [ ] to turn the scale off.
Calibration is complete!
B, MSC-500 Calibration:
1. Turn the scale OFF.
2. While holding the [ M ] key, tap the [ ] key to turn
the scale on then release both keys.
3. The display will show a random number, press the
[ ] key again.
4. The display will show “Zero” followed “500.0”. Place
the required weight on the platform then press the
[ ] key again.
5. The display will show “CAL PASS”. Remove the