American Weigh Scales (AWS) DIA-20 - Manual (Page 6)

DIA-20
then release.
3. 3ress the 02'( keyDJDLQ
The display will flash CAL followed by “10.000g”.
4. Now place a 10g calibration weight on the platform
and wait 3 seconds, the display will flash "20.000g.
5. At this point, place another 10g on the platform to
make a total of 20g on the scale and wait a few
seconds.
6. The display will read “PASS” and then return to normal
weighing mode, calibration is finished! You can turn off
the scale.
X. Troubleshooting
• Problem: Scale will not turn on
• Solution: Check the batteries
• Problem: Displayed weight fluctuates randomly
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
• Problem: Displayed weight is inaccurate
• Solution: Perform a calibration adjustment
XI. Error Codes
1. OUTZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. 88888 - Maximum capacity exceeded. Remove the