American Weigh Scales (AWS) CG2-500 - Manual (Page 4)

press [ PCS ] to confirm.
5. You may now place any number of items on the
platform, and the scale will display a count.
IV. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if the scale is not weighing properly.
**The CG2-500 calibrates with a 500g weight. The
CG2-100 calibrates with a 100g weight (not included)**
1. Turn the scale ON.
2. Hold the [ MODE ] key for a few seconds. The
display will show "CAL", followed by the required
calibration weight.
3. Place the required calibration weight onto the
platform and press [ ].
4. The display will show "PASS" then return to normal
weighin mode. Calibration is complete!
V. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction
are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in
mind and maintain and operate your scale properly.
This scale is a precise instrument and must be
handled with the utmost care and caution.
[Display] Elimination of errors
[OUT2] Recalibrate the scale (Section III).
[EEEE] You are overloading the scale. Remove the
excessive load immediately!
[un2T] Use the scale in a more stable position