American Weigh Scales (AWS) CP4-650 - Manual (Page 4)

1. Turn on scale as described above.
2. Place a tray or container on the scale platform.
3. Press [ TARE ] and wait until "0.0" or "0.00" is
displayed.
4. You can now add items to the container or tray to
obtain just the weight of the contents.
III. PARTS COUNTING
All object must be of equal weight for counting to work.
1. Turn on scale as described above.
2. Place a sample quantity (25, 50, 75, or 100pcs) of
the material you want to count on the platform
3. Press and hold the [ PCS ] key for 2 seconds until a
number is displayed (ie. 100pcs).
4. Press [ UNITS ] to change the sample quantity to
match the number you have on the platform.
5. Press the [ PCS ] key again to confirm the number.
6. You may now remove the sample quantity and add
any amount of the material to the platform, and the
display will show a count.
7. You can switch between weighing and counting
mode by pressing [ PCS ] or [ UNITS ] respectively.
IV. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if scale is not weighing properly.
**The CP4-650 calibrates with a 500g weight (not
included). The CP4-100 calibrates with a 100g weight
(not included)**
1. Turn the scale ON.