Alto Professional AX2304 - Manual (Page 4)

4
INSTALLATION AND CONNECTION
Read this section carefully. Not paying enough attention to the input signal's level, routing, or assignment of
can result in unwanted distortion, a corrupted signal or no sound at all.
Power Connection
Use the same fuse as marked on the fuse holder near the power jack. Connect AX2304 to a standard power
outlet using the enclosed power cable.
Audio Connection
AX2304 uses balanced XLR connectors. It can be connected to other units in a variety of ways to support a
vast range of applications without experiencing signal loss.
Wiring Configuration
XLR servo connectors can be wired in balanced and unbalanced modes. Please wire your systems
according to the following examples:
•
1/4" Phone jack
•
XLR connector
TS Type Unbalanced TRS Type Balanced TRS Type Unbalanced
Tip
Sleeve
Ring Tip
Sleeve
Ring Tip
Sleeve
XLR Type Unbalanced XLR Type Balanced
Pin1
Pin2 (+)
Pin3 (-)
(Linked to Pin1 manually
Pin3 (-)
Pin2 (+)
Pin3 (-)
Pin1
Pin2 (+)
Pin3 (-)
(Linked to Pin1 manually
Pin1