Alto Professional MS18S - Manual (Page 4)

HOOK
UP
2. QUICK START - PASSIVE SPEAKER CABINET
Passive, Full-range, two speakers. This is the simplest set-up. You just need
a mixer and a stereo amplifier. It is good for small club gigs, disco,etc.
Make all initial connections with all the equipment powered off, and ensure that
all the main volume controls are turned down completely.
1). Connect one side of the speaker cable to the Output CHA/CHB or Binding
Post of your stereo power amplifier and the other side to the Input socket
of your MS speaker cabinet.
MIXER
STEREO AMPLIFIER
2
2) Connect the input terminals of LTO MS1 with the AUX SEND OUT (L&R)
of a mixer (or the similar terminals). Connect its output terminals with the
inputs of a power amplifier. Then select the preset as need.
3). Complete other connections as illustrated.
4). Turn on your mixer and MS1 first, then the stereo power amplifier.
5). Turn up the volume controls of your amplifier to about 70%.
6). Use PFL function to get the proper input level for the mixer, and adjust the
Main Mix Level control to manipulate the output level.
7). After using, turn off your stereo power amplifier first, then the mixer and
the MS1.
MS1
INPUT
OUTPUT
VIRTUAL SUB STAGE MONITOR JAZZ CLUB CONCERT HALL+SUB DISCO VOCAL ROCK & ROLL
JAZZ CLUB+SUB
DRUM KICK
ARENA+SUB LOUDNESS ROCK & ROLL+SUB ACOUSTIC
ANTIRUMBLE CONCERT HALL
CLIP
MIN MAX
POWER
M S 1 LTO R SPEAKER MODELLER
0dB
GAIN FLAT
D1
500W 2
(dB)
12 16 18 20 22 24 26 28 30 6 CH1 (dB)
12 16 18 20 22 24 26 28 30 6 CH2
SIG CLIP PROT SIG CLIP PROT
AUX SEND OUT