Alto Professional PS 2TWA User Manual

Page 5

3. SUSPENSION POINT

Suspension Point

Eyebolt

Dust Cover

4. TECHNICAL SPECIFICATIONS

Descriptions

System type

Continuos Power

Peak Power Rating

Sensitivity at 1W, 1mt

Max SPL at 1mt

Frequency Response

Impedance

Crossover Frequency

Lower - Frequency

High - Frequency

High Frequency Protection

Dimensions H W D

Net Weight

Gross Weight lbs/kg

Shipping Volume

kg lbs

PS 2TW

2 - way vented box

150Watt AES Standard

300Watt Peak

96dB SPL

117dB SPL

70Hz / 20kHz +/-10dB

8 ohm Nominal

3000Hz at 12dB/Oct

8" / 208mm - 1.5" voice coil

Electronic Dynamic Protection

595mm

320mm

334.5mm

(23.4"

12.6"

13.2")

10.22kg / 22.53lbs

13.40kg / 29.54lbs

3.68CFT

The AES 2 - 1984 Standard specification by Audio Engineering
Society, is representative and commonly used for the measure
in Professional Sound Reinforcement.

It is defined as the square of the RMS voltage generated with a
pre-defined and band-passed Pink Noise Signal, applied con-
tinuously for 2 hours, on the assembled speaker cabinet.

In this way, the declared power of ALTO passive speaker cabinet,
is comparable to the RMS voltage value, measured on the equiva-
lent power amplifier for the same value of impedance.

First, open the dust covers, and the next, mount the flying
rings to the suspension points (M10 1.5PH LENGTH: 30mm).
For further details, please refer to the right illustration.

The PS 2TW/2TWA speaker cabinet also provides the
suspension points for fixed installation. How to use them?

Descriptions

Powered System type

LOW Output Power

HIGH Output Power

Max SPL at 1m

Frequency Response

Impedance Low - High

Crossover Frequency

Protection Low - High

Low - Frequency

High - Frequency

Horn Coverage H

Input Sensitivity

Input Impedance

Connectors

Plastic Reinforced Cabinet

Hardware Suspension

Amplifier Protections

External Control

Power Supply

Dimensions H W D

Net Weight

Gross Weight lbs/kg

Shipping Volume

kg lbs

PS 2TWA

Bi-Amp. with analog processor

108W RMS Bridge Class AB

45W RMS Class AB

118dB SPL

65Hz / 20kHz +/- 10dB

Low 8Ohm - High 8Ohm

Complex EQ Processor

Limiter / Compressor plus PTC

8" / 208mm - 1.5" voice coil

1" Compression Driver -

1" Voice Coil

90 H

45 V

Line + 4dB / 1.23V

30kohms Balanced -

15kohms Unbalanced

Input with Jack / Link with XLR

Trapezoidal & Monitor shape

Seven suspension points

Soft Start - Short Circuit -

DC voltage - Thermal Protection

Volume - Clip - Ground Switch

230Volt / 115Volt 50 /60Hz