Alto Professional SXA28P - Manual (Page 3)

3
QUICKSTART GUIDE (ENGLISH)
BOX CONTENTS
SXA28P
Quickstart Guide
Safety & Warranty Information Booklet
QUICK SETUP
1.
Make sure all items listed in the BOX CONTENTS section are included in the box.
2. READ SAFETY & WARRANTY INFORMATION BOOKLET BEFORE USING THE PRODUCT.
3. Study the connection diagram in this guide.
4. Place all devices in an appropriate position for operation.
5. Make sure all devices are turned off and all faders and gain knobs are set to "zero."
6. Connect all sound sources' outputs to amplifier inputs as indicated in the diagram.
7. Connect the amplifier outputs to speakers.
8. Plug all devices into an appropriate power source.
9. Switch everything on in the following order:
•
Sound sources (i.e. microphones, turntables, CD players, etc.)
• Mixer
• Amplifier
• Speakers
10. When turning powering down, turn everything off in the following order:
•
Speakers
• Amplifier
• Mixer
• Sound sources
REAR PANEL DIAGRAM
1. High Frequency Configurator (HFC)- Defines the best sound
pressure level in front of the audience. The HFC only works in
Passive mode. The +3 dB position is normally set when the
SXA28P is used in an array to cover a distant audience. The 0dB
is normally used for covering the nearest audience.
2. Input connector- Connect your Speakon cable to these inputs
3. Thru connector- Connect your Speakon cable to this output
4. Frequency Response - The frequency response for the HFC can
be set to either 0dB or +3dB.
LINE ARRAY HARDWARE PARTS
* Speakon is a trademark of Neutrik® AG, registered in the U.S. and other countries.
FB-1
SUB-HD-L SUB-HD-R
SAT-HD-R SH SAT-HD-L
1
2
3
4