Introduction, Presentation – ABUS Technologies HART? Rail Temperature Transmitter User Manual
Page 4

ABUS TECHNOLOGIES INC.
4
HART
Rail
1. INTRODUCTION
Universal head transmitter is used for resistance thermometers (RTD)
, thermocouples
(TC), resistance and voltage transmitter, settable via HART-protocol. The slim housing with
12.5mm wide is used for DIN-rail mounting. Temperature Transmitter with HART-protocol is
mostly applicable in the areas for converting input signals into a scalable 4~20 mA analogue
output signal.
2. PRESENTATION
2.1 Features
1. Universal settings with HART-protocol for various input signals.
2. 2-wire technology, 4~20 mA analogue output,
3. High accuracy in total ambient temperature range.
4. Galvanic isolation.
5. An internal temperature sensor for active temperature compensation.
6. Wide voltage supply range.
7. Customer specific measurement range settings,
8. Simple and user friendly software.
2.2 Technical Parameters
OUTPUT
Output signal:
4 ~ 20 mA
Signal on alarm:
Under ranging Linear drop to 3.8 mA.
Over ranging Linear rise to 20.8 mA.
Sensor Break; Sensor open-circuit 3.8 mA.
Load:
max.(V
Power Supply
-7.5 V)/0.0208 A
Linearization/Transmission behaviour: Temperature linear, resistance linear, voltage
linear.
Galvanic isolation:
U=2 KV AC (input/output).
Power Supply (polarity protected):
7.5 ~ 45 VDC (without display).
PERFORMANCE
Response time:
1s
Reference operating conditions:
Calibration temperature 23°C (73.4°F) ±5K
Long term stability:
≤0.05% per year.
Switch on delay:
≤ 5s
Influence of ambient:
Negligible
Load Influence:
Negligible
Power Supply Influence:
Negligible
Self stability configuration:
0 ~ 2%
Filter configuring:
0 ~ 160 μ A
Resolution:
0.3 μ A