Dixon 25 KOH/968999580 - Manual (Page 38)

CARE AND MAINTENANCE
38
CAUTION HOT oil may cause burns. Allow
engine to cool before draining oil.
Hex Head Valve
Stem
CHANGING THE ENGINE OIL:
1. The oil drain valve is located on either side of the
engine crankcase (depending on the type of engine
installed on your ZTR®).
2. Place a suitable container under the drain valve
hose.
3. To drain, turn hex head valve stem counter-clockwise
with a 10mm wrench or socket. Open to full open
(approximately 7 turns).
4. After engine is drained, tighten hex stem.
5. Change oil filter.
6. Fill with oil (see steps on next page).
NOTE: Refer to engine manufacturer’s recommenda-
tions for frequency of oil changes.