Tascam CD-01U - Manual (Page 12)

1 ANALOG OUTPUT terminals
The analog line output terminals are for RCA pin
jacks. The maximum output level is +6 dBV.
2 DIGITAL (OPTICAL) OUTPUT terminal
Provides the digital audio signal in S/PDIF format.
This connector outputs the 44.1KHz digital signals
constantly even if pitch control is activated.
3 CONTROL I/O (RS-232C) connector
This RS-232C interface allows control by a computer
or by other serial controllers. Consult your TASCAM
dealer the TASCAM web site for details of this port if
you wish to use it.
4 RELAY IN/OUT jacks
These jacks are used to perform the relay play
operation between two or more CD-01U/CD-01U
Pro, or perform the fader start or event start
operation.
5 ANALOG OUTPUT (BALANCED) terminals (CD-
01U Pro only)
The analog line output terminals are for XLR
connectors. The maximum output level is +20 dBu.
6DIGITAL (AES/EBU) OUTPUT terminal (CD-01U
Pro only)
Provides the digital audio signal in AES/EBU format.
This connector outputs the 44.1KHz digital signals
constantly even if both control is activated.
7CONTROL I/O (PARALLEL) connector (CD-01U
Pro only)
Parallel control from an external devices can be
performed.
8 IN
Connect the power cable supplied with the CD-
01U/CD-01U Pro.
4 - Features and their functions
Rear panel
Remote Control Unit
1 EJECT BLOCK key
This turns the Eject Block mode on and off.
2 DISPLAY key
Pressing this key changes the time mode on the
display.
3 PLAY MODE key
This selects the playback mode. During selection, the
playback mode is indicated on the display in the
following manner.
Normal playback (in disc order): no indication
Single playback: S lights up
Program playback: PGM lights up
Random playback: RANDOM lights up
4 EJECT key
Press this to eject the disc. This key cannot be used
when Eject Block mode is on and the disc is being
played back.
12
TASCAM CD-01U/CD-01UPro