MIPRO act707se_ii(2ce158)c - Manual (Page 3)

2 3
ACT SINGLE CHANNEL WIRELESS RECEIVER ACT SINGLE CHANNEL WIRELESS RECEIVER
2. PARTS NAME AND FUNCTIONS
Front Panel：
Rear Panel：
(Fig.1)
(Fig.2)
(1) Front Antenna A Input Connector : Allows an optional rear-to-front
Antenna kit for front antenna placement.
(2) Power Switch & Indicator: When switch is turned on, red indicator
illuminates to denote normal power status.
(3) ACT Button: To setup microphone frequency to match receiver frequency.
(4) Scan Button: Press once to select receiving channel and autoscan the
whole bandwidth to avoid interference channel.
(5) Channel Indicator: To display system's receiving channel.
(6) RF Signal Level Indicator: Indicate the RF signal strength received.
(7) Audio Signal Level Indicator: Indicate the audio signal level.
(8) Noise Indicator: To display if the system is under interference.
(9) Front Antenna B Input Connector : Allows an optional rear-to-front
Antenna kit for front antenna placement.
(10) Antenna B input Connector: Antenna B connector can be installed with
antenna directly and provides power for antenna booster.
(11) Balanced Audio Output Jack: With Cannon / XLR type connector provides
balanced audio output signal from this jack to the amplifier.
(12) Unbalanced Level Switch: "MIC" selection is for "Microphone-level" output.
"LINE" selection is for "Line-out" level output.
(13) Unbalanced Audio Output Jack: With 1/ 4 Phone Jack provides audio
output signal from this jack to the amplifier.
(14) Squelch Adjuster: Adjust the squelch level to eliminate the RF noise
interference at receiver stand-by state.
(15) DC Input Socket: The input socket for 12 Volt DC power. Please note
that the polarity of the central pin in the socket is positive (+).
(16) Antenna A Input Connector: Antenna A connector can be installed with
antenna directly and provides power for antenna booster.
(17) Rackmount Bracket: To install the receiver into an EIA 19-inch standard
rack case.
λ
Switch
between "LINE" and "MIC" for different purposes.
Switch between "LINE" and
"MIC" for different purposes.
NOISE
A F
R F CHANNEL
N o .
1 2 5 6 8
4 7
9
S C A N
ACT
3
10 11 12 13 15 16 14 17