MIPRO act707de(2ce143d) - Manual (Page 9)

BELT PACK TRANSMITTER BELT PACK TRANSMITTER
3. AF 4-PIN INPUT CONNECTION METHODS
(1) 2-Wire Electret condenser microphone Capsule
(2) 3-Wire Electret condenser microphone Capsule
(3) Dynamic Microphone
(4) Electric Guitar
(5) Line-in (Impedance 8K ATT. 10dB) Ω
AUDIO
SHIELD
4
3
2
1
PIN
4PIN
PLUG
SHIELD
AUDIO
BIAS
3
4
PIN
1
2
4PIN
PLUG
AUDIO
SHIELD
1
4
3
2
PIN
4PIN
PLUG
SHIELD
AUDIO
3
2 1
PIN
4
3
2
1
4PIN
PLUG
SHIELD
AUDIO
1
3
4
2
PIN
4PIN
PLUG
4. BATTERY INSTALLATION
1. Pushing down both snap locks o n the sides of battery cover toopen
battery cover. Take out the batteries. Fig.(3).
2. Insert a 9Vbattery into the battery compartment according to the correct
polarity as shown in Fig. (4). Then push up to close the battery
compartment as shown in Fig.(4).
(Fig.4) (Fig.3)
Under normal operation, when receiver and transmitter are paired together
to set frequency, microphone indicator (3)will remain off after ACT setup the
frequency. However, if indicator (3) is flashing, it means receiver and
transmitter are not in the same frequencyband. Please check the stickers on
transmitter and receiver to observe if they are sharing the same frequency
bands.
5. CAUTIONS
1 4 15