Optoma DAC80 - Manual (Page 3)

2
NuForce DAC-80 Digital to Analog Converter
QUICK START GUIDE
Product Overview
Front Panel
44.1k
48.0k
88.2k
96.0k
176.4k
192.0k
Back Panel
AC 100(115)V / 230(240)V
FUSE T2.5A 250V
OPTICAL
3
USB
1
COAXIAL
2
COAXIAL
4
100V
115V R L
240V
230V
Make sure that the AC Voltage selector switch at the rear of the unit is switched to the appropriate voltage for
your country. All DAC-80s are shipped with the switch set to 230VAC in order to prevent accidental damage.
Turn ON the AC power switch at the rear of the unit. The DAC-80 will now be in standby mode.
The logic On/Off is enabled by pushing the knob or using the remote. The DAC-80 consumes less than 1W in
standby and approximately 10W when ON.
When turned ON from the standby state, the DAC-80 requires six seconds to stabilize. During that period, the LED
will blink and the output will be muted.