beautypg.com

Trip computer (if so equipped) -5 – NISSAN 2009 Pathfinder User Manual

Page 81

background image

For vehicles equipped with trip computer, push-

ing the change button changes the display as

follows:

Trip

→ Trip

→ Distance to Empty →

Average speed

→ Average fuel consumption →

Journey time

→ Trip

For additional information, refer to “Trip com-

puter” later in this section.
For vehicles equipped with navigation system,

refer to “How to use the INFO button” in the

“Display screen, heater, air conditioner and audio

systems” section later in this manual.

Resetting the trip odometer:

Pushing the change button for more than 1 sec-

ond resets the currently displayed trip odometer

to zero.

TRIP COMPUTER (if so equipped)

The display of the trip computer is situated in the

speedometer display. When the ignition switch is

placed in the ON position, the display scrolls all

the modes of the trip computer and then shows

the mode chosen before the ignition switch was

placed in the OFF position.
When the ignition switch is placed in the ON

position, modes of the trip computer can be

selected by pushing the trip computer change

button. The following modes can be selected:

Distance to empty (dte—mile or km)

The distance to empty (dte) mode provides you

with an estimation of the distance that can be

driven before refueling. The dte is constantly be-

ing calculated, based on the amount of fuel in the

fuel tank and the actual fuel consumption.
The display is updated every 30 seconds.
The dte mode includes a low range warning

feature: when the fuel level is low, the dte mode is

automatically selected and the digits blink in or-

der to draw the driver’s attention. Press the

change button if you wish to return to the mode

that was selected before the warning occurred.

The dte mark (dte) will remain blinking until the

vehicle is refueled.
When the fuel level drops even lower, the dte

display will change to (----).

NOTE:

If the amount of fuel added while the

ignition switch is OFF is small, the dis-

play just before the ignition switch is

turned OFF may continue to be dis-

played.

When driving uphill or rounding curves,

the fuel in the tank shifts, which may

momentarily change the display.

Average speed (MPH or km/h)

The average speed mode shows the average

vehicle speed since last reset. Resetting is done

by pressing the change button for more than

approximately 1 second. The display is updated

every 30 seconds. The first 30 seconds after a

reset, the display shows (----).

Average fuel consumption (Mpg or

l/100km)

The average fuel consumption mode shows the

average fuel consumption since the last reset.

With trip computer

LIC0781

Instruments and controls

2-5

REVIEW COPY—

2009 Pathfinder (pat)

Owners Manual—USA_English (nna)
05/29/08—debbie

This manual is related to the following products: