NISSAN 2009 Frontier - Manual (Page 141)

grammed device, press and hold the pro-
grammed HomeLink ா button — releasing
when the device begins to activate.
5. If the indicator light on the HomeLink ா blinks
rapidly for 2 seconds and then turns solid,
HomeLink ா has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLink ா to complete the programming
which may require a ladder and another per-
son for convenience.
6. Press and release the “smart” or “learn” pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the lens to
access the program button.
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light” is lit, you
have 30 seconds in which to perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
7. Within 30 seconds of pressing and releas-
ing the garage door opener’s program but-
ton, quickly and firmly press and release the
HomeLink ா button you’ve just programmed.
Press and release the HomeLink ா button up
to 3 times to complete the training.
8. Your HomeLink ா button should now be pro-
grammed. (To program the remaining
HomeLink ா buttons for additional door or
gate openers, follow steps 2-4 only.)
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLink ா buttons.
If you have any questions or are having difficulty
programming your HomeLink ா buttons, refer to
the HomeLink ா web site at: www.homelink.com
or call 1-800-355-3515.
PROGRAMMING HOMELINK ா FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2 sec-
onds. To program your hand-held transmitter to
HomeLink ா, continue to press and hold the
HomeLink ா button (see steps 2 - 4 under “Pro-
gramming HomeLink ா”) while you press and re-
press (“cycle”) your hand-held transmitters every
2 seconds until the indicator light flashes rapidly
(indicating successful programming).
NOTE:
When programming a garage door opener,
etc., it is advised to unplug the device dur-
ing the “cycling” process to prevent pos-
sible damage to the garage door opener
components.
OPERATING THE HOMELINK ா
UNIVERSAL TRANSCEIVER
The HomeLink ா Universal Transceiver (once pro-
grammed) may now be used to activate the ga-
rage door, etc. To operate, simply press the ap-
propriate programmed HomeLink ா Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLink ா does not quickly learn the hand-
held transmitter information:
● replace the hand-held transmitter batteries
with new batteries.
● position the hand-held transmitter with its
battery area facing away from the
HomeLink ா surface.
● press and hold both the HomeLinkா and
hand-held transmitter buttons without inter-
ruption.
Instruments and controls 2-53
੬
REVIEW COPY— 2009 08+ Truck/Frontier (fro)
Owners Manual—USA_English (nna)
05/27/08—debbie
੭