NISSAN 2010 Altima - Manual (Page 236)

iPod
ா* PLAYER OPERATION WITH
NAVIGATION SYSTEM (if so
equipped)
Connecting iPod
ா
To connect an iPod ா to the vehicle so that the
iPod
ா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open the protec-
tive cover
᭺
1 on the USB jack in the center
console. Then connect the iPod
ா-specific end of
the cable to the iPod ா and the USB end of the
cable to the USB jack on the vehicle. If your iPod ா
supports charging via a USB connection, its bat-
tery will be charged while connected to the ve-
hicle with the ignition switch in the ACC or ON
position.
While connected to the vehicle, the iPod
ா can
only be operated by the vehicle audio controls.
To disconnect the iPod
ா from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod
ா.
* iPod
ா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are available:
● iPodா 5th Generation version 1.2.1
● iPodா Classic - version 1.1.1
● iPodா Touch - version 2.0.0
● iPodா Nano - 1st generation version 1.3.1
● iPodா Nano - 2nd generation version 1.1.3
● iPodா Nano - 3rd generation version 1.1
● iPodா Nano - 4thgeneration version 1.0.2
Make sure that your iPod ா firmware is updated.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the DISC·AUX button repeatedly
to switch to the iPod
ா mode.
If the system has been turned off while the iPod
ா
was playing, pressing the VOL/ON·OFF control
knob will start the iPod
ா.
DISC·AUX button:
When the DISC·AUX button is pressed with the
system off and the iPod
ா connected, the system
will turn on. If another audio source is playing and
the iPod
ா is connected, press the DISC·AUX
button repeatedly until the center display
changes to the iPod
ா mode.
LHA1357 LHA1397
Monitor, climate, audio, phone and voice recognition systems 4-75