beautypg.com

Push starting -10 if your vehicle overheats -10 – NISSAN 2011 Altima User Manual

Page 347

background image

CAUTION

Always connect positive (ϩ) to positive

(

ϩ) and negative (Ϫ) to body ground (for

example, strut mounting bolt, engine
lift bracket, etc.) — not to the battery.

Make sure the jumper cables do not

touch moving parts in the engine com-
partment and that the cable clamps do
not contact any other metal.

5. Start the engine of the booster vehicle and

let it run for a few minutes.

6. Keep the engine speed of the booster ve-

hicle at about 2,000 rpm, and start the en-
gine of the vehicle being jump started.

CAUTION

Do not keep the starter motor engaged for
more than 10 seconds. If the engine does
not start right away, turn the key off and
wait 3 to 4 seconds before trying again.

7. After starting the engine, carefully discon-

nect the negative cable and then the positive
cable.

8. Replace the vent caps (if so equipped). Be

sure to dispose of the cloth used to cover
the vent holes as it may be contaminated
with corrosive acid.

CAUTION

Do not push start this vehicle. The

three-way catalyst may be damaged.

Continuously Variable Transmission

(CVT) models cannot be push-started or
tow-started. Attempting to do so may
cause transmission damage.

For manual transmission (M/T) models,

never try to start the vehicle by towing
it. When the engine starts, the forward
surge could cause the vehicle to collide
with the tow vehicle.

If your vehicle is overheating (indicated by an
extremely high temperature gauge reading), or if
you feel a lack of engine power, detect abnormal
noise, etc., take the following steps.

WARNING

Do not continue to drive if your vehicle

overheats. Doing so could cause engine
damage or a vehicle fire.

To avoid the danger of being scalded,

never remove the radiator cap while the
engine is still hot. When the radiator
cap is removed, pressurized hot water
will spurt out, possibly causing serious
injury.

Do not open the hood if steam is com-

ing out.

1. Move the vehicle safely off the road, apply

the parking brake and move the shift selector
to N (Neutral) (manual transmission) or to P
(Park) (CVT).

Do not stop the engine.

2. Turn off the air conditioner. Open all the

windows, move the heater or air conditioner
temperature control to maximum hot and fan
control to high speed.

PUSH STARTING

IF YOUR VEHICLE OVERHEATS

6-10

In case of emergency