Dixon 3500 Series - Manual (Page 13)

13
SPECIFICATIONS
Model ZTR 3530 & 3536
CHASSIS: 1X2X11 gauge welded tube, 7 gauge transmission and engine
base plate.
BODY: All body parts made of high density polyethylene. Dent and corrosion
resistant.
MOWER DECK: 30” Deck: 11 GA Stamped Steel Construction-30” Cut Width.
36” Deck: 11 GA Fabricated Construction/Reinforcement Ribs-36”
Cut Width. Cut height approximately 1” to 4” via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by a HydroGear IZT
hydrostatic drive.
ENGINE:
Model 3530: 13.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft with Cast Iron Cylinder
Sleeve, pressure lube with spin-on filter.
Model 3536: 14.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft with Cast Iron Cylinder
Sleeve, pressure lube with spin-on filter.
STARTING Electric by key switch operation with safety interlock blade and
SYSTEM : traction drive.
TIRES: Front 11 x 4.00 x 5 ribbed tread
Rear 18 x 8.50 x 8 (3536)
Rear 18 x 7.00 x 8 Multi Trac (3530)
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 3.3 gallons total
Engine 1.5 quarts oil
DIMENSIONS: Width 44” maximum track width
Height 42” to top edge of seat
Length 73” hitch tab to front bumper
Weight 3530 - 512 lbs 3536 - 554 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE