Technology for driving comfort and safety – Mini 2009 Cooper Convertible User Manual

Page 70

Technology for driving comfort and

safety

Reduce speed and stop the vehicle with cau-
tion. Avoid sudden braking and steering
maneuvers.

Check whether your vehicle is equipped
with normal tires or Run-Flat Tires.

The symbol identifying Run-Flat Tires
is a circle with the letters RSC on the

sidewall, refer to the Owner's Manual for
Vehicle.

Normal tires

Determine which tire is damaged.

If this cannot be determined, contact
your MINI Dealer.

Repair the flat tire or change the damaged
tire, refer to page

129

Run-Flat Tires*

Cautiously reduce speed to below
50 mph/80 km/h. Avoid sudden braking and
steering maneuvers. Do not exceed a speed
of 50 mph/80 km/h.

Do not continue driving if the vehicle is
not equipped with Run-Flat Tires, oth-

erwise a serious accident could result.

In the event of complete tire pressure loss,
0 psi/0 kPa, you can estimate the possible
distance for continued driving on the basis
of the following guidelines:

With a light load:
1 to 2 persons without luggage:
approx. 155 miles/250 km

With a medium load:
2 persons, cargo bay full, or 4 persons
without luggage:
approx. 94 miles/150 km

With a full load:
4 persons, load compartment full:
approx. 30 miles/50 km

Drive cautiously and do not exceed a
speed of 50 mph/80 km/h, otherwise an

accident may occur. In the event of pressure
loss, vehicle handling changes. This includes
reduced tracking stability in braking, extended
braking distance and altered natural steering
characteristics.
If unusual vibration or loud noises occur during
the journey, this may be an indication that the
damaged tire has finally failed. Reduce the vehi-
cle speed and stop as soon as possible. Other-
wise, sections of the tire may come loose and
cause accidents. Do not continue driving and
contact your MINI Dealer.

Malfunction

The small warning lamp flashes in yel-
low and then lights up continuously; the
larger warning lamp comes on in yel-
low.

On the onboard monitor, the tires are shown in
gray and a message appears. No punctures can
be detected.
This type of message is shown in the following
situations:

If there is a malfunction.
Have the system checked.

If a wheel without TPM electronics has been
mounted.

If TPM is temporarily malfunctioning due to
other systems or devices using the same
radio frequency.

Message for unsuccessful system reset

Both warning lamps come on in yellow.
The system is not reset after a tire has
been changed, for example.
Check the tire inflation pressure and

reset the system, refer to the Owner's Manual
for Vehicle.