Replacing components – Mini 2011 Countryman User Manual

Page 134

Replacing components

132

Headlight glass lens

In cool or humid weather, condensation may
occur on the interior of outside lights. The con-
densation disappears a short time after the light
is switched on. The headlamps do not need to
be changed. If a lot of moisture is present, e.g.
water droplets in the light, have them checked
by your service center.

Xenon lamps*

The service life of these bulbs is very long and
the probability of failure very low, provided that
they are not switched on and off an excessive
number of times. If a xenon lamp fails neverthe-
less, switch on the fog lamps and continue the
journey with great care, provided that local leg-
islation does not prohibit this.

Have any work on the xenon lamp system,
including bulb replacement, carried out

only by a MINI dealer or a workshop that has
specially trained personnel working in accor-
dance with the specifications of the MINI manu-
facturer. Due to high voltage, there is a risk of
fatal injury if work on the xenon lamps is carried
out improperly.

Halogen low beams and high beams

H13 bulb, 60/55 watts

The H13 bulb is pressurized. Therefore,
wear safety glasses and protective gloves.

Otherwise, there is a risk of injury if the bulb is
damaged.

Be careful when installing the cover; oth-
erwise, leaks could occur and cause dam-

age to the headlamp system.

Accessing the lamp from the engine
compartment

The low-beam/high-beam bulb can be changed
from the engine compartment.

Removing the cover:

Press the tab.

Flip open the cover and take it out of the
holder.

Follow the same steps in reverse order to reat-
tach the cover.

Be careful when installing the cover; oth-
erwise, leaks could occur and cause dam-

age to the headlamp system.

Replacing the bulb

Turn the lamp counterclockwise, arrow 1,
and remove it, arrow 2.

Push on the catch, arrow 1, and disconnect
the connector, arrow 2.

To insert the new bulb and replace the
cover, proceed in reverse order.