Lenco Xemio-244 User Manual
Page 4
XEMIO-244 / 254
USER MANUAL
4
9.
Earphone Out Jack:
To connect stereo earphone set
10. Clip
C. Getting start player
1
Turn On / Off
1.1
Plug-in the earphone set into player’s earphone out jack
1.2
Press and hold
button, for 2 - 3 seconds, to turn On and the music will
play directly.
1.3
Press and hold
button, for 2 - 3 seconds, to turn Off.
2
Play / Pause Music
2.1
Press
button to pause the playing music,
2.2
Press
button again to resume.
2.3
If player is in pause state for 3 minutes, it will be turned to Off automatically.
2.4
When press
button, if no music files are stored in player’s memory, the
status LED blinking fast for few seconds and the player will turn to Off
automatically.
3
Adjust Volume
3.1
Press and hold
/
button to increase volume level.
3.2
Press and hold
/
button
to decrease volume level.
3.3
For hearing protection; a beep warning will be heard from earphone every
time you increase the volume level and reach to the default setting level,
which may exceed 85dB. Press
button to accept the warning and press
and hold
/
button again to increase the level until to maximum level.
4
Play Next / Previous Music
4.1
Press
/
button to select next music.
4.2
Press
/
button to select previous music.
5
Shuffle On / Off
5.1
Press
button to switch to shuffle play from in order play, the status LED
light will flashing slow for 2 seconds once.
5.2
Press
button again to return to in order play, the status LED light will
flashing for 1 second once.
5.3
Shuffle play is only allowed playing in cycle on internal memory play or on
Micro SD memory card play.
5.4
Press and hold
button for 2 – 3 seconds to switch in between the
internal memory play and Micro SD memory card play if external memory
card inserted and shuffle function is in use.
D. Micro USB
1
Connect player to computer
1.1
Connect the player to the computer by using the USB cable. Now the
computer will detect and install the driver automatically. Once the installation
is complete, the player will be displayed in “My Computer” or for MAC users