Preset eq, Aux in operation, Charging your smart phone or portable device – Lenco SR-600 BT User Manual
Page 10
E-9
This feature is phone dependent and may not operate on all cell phones
or devices.
PRESET EQ
The SR-600 BT features 5 different EQ modes to enhance your listening experience.
You can select the desired effect by press and hold
the “EQ” button repeatedly at
following sequence:
CLASSIC
ROCK
FLAT
POP
JAZZ
AUX IN OPERATION
You can play other music sources (iPod, MP3 or other digital audio players) through
the speakers of
the
SR-600 BT by connecting the AUX IN Jack (#17) to your external
player
’s audio out jack or headphone jack.
1. Plug one end of an audio cable (not included) into the AUX IN Jack (#17) and the
other end of the cable to the headphone jack of your digital audio player
.
2. Turn ON the unit and your external audio.
3. Tap the
button (#10) to select AUX mode. AUX will appear on LED
Display (#12).
4. Start playing the device you plugged into the AUX IN Jack (#17).
.
5. Slowly adjust both the volume controls of your SR-600 BT and the external device
until you reach a comfortable listening level.
Note :
•
If you connect
the
SR-600 BT to the Line-Out Jack of your external device, you
only need to adjust the VOLUME CONTROL of the SR-600 BT. If you connect to
the Headphone Jack of your external device, you may need to adjust both the
volume controls of your external device and
the
SR-600 BT to obtain the desirable
listening level.
•
Remember to turn off the SR-600 BT when you have finished listening. Don't
forget to switch off the power of your external audio device as well.
CHARGING YOUR SMART PHONE OR PORTABLE DEVICE
The SR-600 BT features a USB port for charging your portable device (iPod, iPhone,
Android phone, etc.).
Note : USB charging only works when unit operates in AC power mode via the AC
adaptor (included).
1. When the AC power is connected, switch the MAIN POWER ON/OFF SWITCH
(#15) on the back of the unit to ON position.
2. Plug the standard end of the USB cable (not included) into the USB CHARGING
PORT (#16) located on the back of the SR-600 BT. Plug the other end of the