Lenco SR-03 BT - Manual (Page 7)

UK-6
DISPLAY BACKLIGHT
The display backlight is defaulted to dim in standby and will go to on once the unit is switched to on. It
would be reset back to the default every time the unit is switched to standby.
During unit on, press the BACKLIGHT button will toggle the backlight between on and dim.
During standby, press on any of the buttons will turn on the backlight for 10 seconds.
AUX INPUT
There is a 3.5mm stereo aux input socket located at the back of the unit; analogue audio sound signals
from other sources can be input to the radio through this socket.
To select AUX mode, repeatedly press the MODE button until “AUX” is displayed, the audio will be
switched to the aux input signal and you can adjust the volume control for your desired sound output level.
HEADPHONE JACK
The stereo headphone jack is located on the back panel. Connect a set of stereo headphones (not
included) to this jack for private listening. When headphones are in use, the speaker will be automatically
cut off.
IMPORTANT: When using headphones always set the volume control to a low level before you put the
headphones on, then put the headphones on and gradually increase the volume to a comfortable listening
level.
LCD DISPLAY WINDOW
BLUETOOTH SECTION
BLUETOOTH SPECIFICATION V2.1+ EDR
OUTPUT POWER CLASS Class 2
SUPPORTING PROFILES A2DP, AVRCP
A. BLUETOOTH INDICATOR
B. TUNER INDICATOR
C. FM STEREO INDICATOR
D. TIME/FREQUENCY RANGE INDICATOR
E. ALARM INDICATOR
F. USB INDICATOR
G. SLEEP INDICATOR
H. SNOOZE INDICATOR
SPECIFICATION
POWER SUPPLY:
AC 100-240V~ 50/60Hz
OUTPUT POWER: 2 x 5W
UNIT DIMENSION : 300 (L) x 145 (W) x 115 (H) mm
RADIO SECTION
FREQUENCY RANGE:
FM 87.5 - 108 MHz
USB SECTION
INTERFACE
USB 1.1 (USB HUB not supported)
FLASH MEMORY USB 1.1 Flash USB 2.0 High-Speed Flash
FAT 16/32 32M 2TByte
MP3 DECODER
MPEG Audio 1, 2, 2.5 Layer 1, 2, 3
Bit Rate 8 - 320kbps & VBR except free format
SPECIFICATION SUBJECT TO CHANGE WITHOUT FURTHER NOTICE.
B C D E
F G H
F M
P M
SNOOZE
TUNER
NO DATA
USB
HI
AUX
SLEEP
A