Lenco MES-202 - Manual (Page 5)

4
BASIC CONNECTION
 Mains plug or appliance connector shall be used as the disconnect device, so mains plug or appliance connector should
always remain readily operable.
y
It is recommended to connect a multi-system TV.
y Ensure that this player and other equipment to be connected are set to the standby mode or off and disconnect the AC power
cords before commencing connection.
y
Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely.
y Read through the instructions before connecting other equipment.
y
Ensure that you observe the color coding when connecting audio and video cables.
NOTE: ALTHOUGH THE MES-202 IS EQUIPPED WITH A CHARGING LED, THE UNIT COMES WITHOUT A
RECHARGEABLE BATTERY AND AC ADAPTOR!
Note:
y
During DVD play, the TV volume may be at a lower level than during TV broadcasts, etc. If this is the case, adjust the volume
to the desired level.
y
If the DVD/CD player is connected to the TV through a video cassette recorder, the picture may not be played back normally
with some DVDs. If this is the case, do not connect the player via the VCR.
Connecting to a stereo TV set
AUDIO R AUDIO L VIDEO IN
S-VIDEO
YUV INPUT
AV AUDIO/VIDEO INPUT
Connecting to an affiliated screen
This unit is equipped with another affiliated screen,
you can use the affiliated screen and player to
appreciate the programme at the same time, the
connecting method is illustrated as below using the in
car adaptor.
A/V cable
TV SET
To the cigarette lighter socket
Slave screen connector