Lenco Lucille - Manual (Page 6)

EN-5
Bluetooth Operating
This unit can receive stereo audio signal from a Bluetooth stereo audio source device.
1. Power on the unit. Switch to Bluetooth mode by pressing the FUNCTION button repeatedly.
2. “PAIRING” flashes on the display while Bluetooth is pairing.
3. Enable the Bluetooth function of the Bluetooth audio source device.
4. Pair and connect to LENCO-LUCILLE (this unit) on the audio source device. If prompted for
passcode, enter “0000”.
5. When pairing is successful, “CONNECT” shows on the display, and it is ready to stream music. Press
the ENTER/PLAY/PAUSE button on the unit if the playback does not start automatically, or operate
the audio source device to start playback.
6. During playback, press the ENTER/PLAY/PAUSE button to cease or resume the playback.
7. During playback, turn the TUNING/SKIP knob clockwise/anticlockwise to skip to the next/previous
track.
Note: The above steps for Bluetooth connection and playback are intended for reference purpose only.
Please refer to the instruction manual of the Bluetooth audio source device for more details.
Disconnection/Reconnection to the Bluetooth Audio Source
Press the POWER button to turn off the unit, and to disconnect the Bluetooth device.
Turn on the unit and switch to Bluetooth mode to automatically retrieve the last paired Bluetooth device.
Note:
y
When the external Bluetooth source device is moved out of the Bluetooth receiving range of the unit,
the Bluetooth connection will be disconnected. Moving again into the receiving range will resume
connection and restart playback through the unit automatically. If otherwise the connection does not
resume automatically, please operate as above to reconnect and start playback.
y
Simultaneous connection of two external Bluetooth audio devices to the unit is not supported. First
press and hold the MENU/BLUETOOTH PAIR button on the unit (or operate your audio source
device) to disconnect current connection, at the same time the unit will launch a new pairing, now
you can operate another audio source device to make Bluetooth connection with the unit and start
playback.
NFC (Near Field Communication)
This unit has NFC function, which allows an NFC-enabled Bluetooth audio source device to rapidly
connect with the unit and play the audio signal through the unit. Operate as below:
1. Turn the unit on. Activate the NFC function of a Bluetooth audio source device such as a
smartphone.
2. Hold the audio source device close to the NFC scanning area of the unit (in a range within 10cm).
The audio source device will pair and connect with the unit instantly. If the unit is in other modes, it
will be switched to Bluetooth mode automatically.
3. Operate the audio source device to select your desired music to play through the unit. Please refer to
the instruction manual of your NFC audio source device for more details.
USB Charging Port
The USB charging port on the back of the radio is only used to output a 5V/1A current to a USB external
device for charging when the unit is switched on.
IMPORTANT SAFETY INSTRUCTIONS
y The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
y When the AC/DC adapter is used as the disconnect device, the disconnect device shall remain
readily operable. To be completely disconnected the power input, the AC/DC adapter shall be
disconnected from the mains completely.
y No naked flame sources, such as lighted candles, should be placed on the apparatus.