Lenco LED-2214 - Manual (Page 16)

You can select the input source menu by pressing the Source button on the remote control or
the INPUT button on the TV.
Auto installation setup
Source Menu
Power On / Off the TV
INPUT SOURCE
ATV
DTV
HDMI
SCART
YPBPR
AV
VGA
DVD
13
1.Connect the AC/DC power adapter with the TV and the AC outlet.
2.Connect the analogue antenna cable or DVB-T
DQWHQQDWRWKH5)ȍ
socket.
3.Switch on the TV by pressing the power button.
4.The “The First time installation”menu will appear on your screen.(Picture
below).
IMPORTANT NOTE:
So if only the analogue antenna cable is
connected you will get no
signal(below picture)because the default
mode is DTV and not ATV
(ATV=Analogue cable).you can switch to
ATV mode as follow:
1.Press “input” button
2.Select “ATV” source
5.Press “OK” button on the remote control to start the Tuning process.The
TV will automatically find all available ATV and/or DTV channels and
store them.
After the First Time Installation winzard is
complete the TV will enter the default source
DTV mode(DTV mode=DVB-T)