Lenco IPD-4100 - Manual (Page 14)

13
Problem Possible Cause What to do
Radio sound distorted. 1.The station is not tuned in.
2.There is a poor signal in the
area.
1.Fine tune the station.
2.Reposition the Speaker
Dock.
No radio sound. 1.The Speaker Dock is not in
tuner mode.
2.The volume has been muted
or is on the minimum setting.
1.Press the MODE button until
Tuner is selected.
2. Adjust the volume level.
The iPod will not play 1.The Speaker Dock is not in
iPod mode.
2.The iPod is not connected
correctly.
1.Press the MODE button until
iPod is selected.
2.Reconnect the iPod.
No iPod sound. 1.The Speaker Dock is not in
iPod mode.
2.The volume has been muted
or is on the minimum setting.
1.Press the MODE button until
iPod is selected.
2.Adjust the volume level.
If none of the above solves your problem, perform a reset as described on page 11.
Model Number
• IPD-4100/2
Power Supply
• AC ～ 110-240V 50Hz
Power Consumption • 40 W
Power Output • 10W x 2 + 20 W (Subwoofer)
Radio Frequency Coverage • FM: 87.5MHz - 108 MHz
Dimensions • 402mm (L) x 265mm (W) x 140mm (H)
IMPORTANT: Due to continual revision and improvements to our products design,
specifications are subject to change without notice.