Lenco DVD-226 - Manual (Page 15)

14
Troubleshooting
If you have any questions, please consult the troubleshooting guide below.
NO PICTURE OR SOUND
• Ensure the power button is on.
• Ensure the power outlet is operational.
* Ensure the power cord is not damaged.
* Ensure the power plug is connected firmly to the
outlet.
"BAD DISC" DISPLAYED
* Ensure the disc is not warped, damaged or deformed.
* Ensure the disc is not badly stained or damaged.
* Ensure the disc format is compatible with the player.
* Please check whether you have tried to play a software CD.
If so, please restart the player.
PICTURE BUT NO SOUND
* Ensure the audio jacks are securely connected.
* Ensure the audio connector is not damaged.
* Ensure the volume is turned up in VOUCH setup.
* Ensure you have set the player's AUDIO settings correctly.
* Ensure you have entered the correct AV input for your TV
* Ensure the audio is not set to mute.
REMOTE NOT WORKING
• Make sure the Main units POWER button is on
• Ensure the remote batteries are working.
• Point the remote control directly at the player's IR
sensor.
• Remove any obstacles between the remote and
the IR sensor.
SOUND BUT NO PICTURE
* Ensure the video jacks are securely connected.
* Ensure you have entered the correct AV input for your TV
* Ensure the video connector is not damaged.
* Ensure you have set the player's VIDEO settings correctly.
UNIT NOT WORKING
• Turn off the power, and then turn it on again.
POOR PICTURE OR SOUND
* Ensure you have set the player's AUDIO settings correctly.
* Ensure the disc is not scratched or stained.
* Ensure the AV connector or the output terminal is not
damaged.
"NO DISC" DISPLAYED
. • Ensure you have put the disc on the tray.
* Ensure the disc is not upside down.
* Ensure the disc is not distorted, stained or
scratched.