Lenco CS-455 BT - Manual (Page 6)

5
7)BEEP ON/BEEP OFF
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled..
8)VOL LAST/VOL DEFA
VOL LAST: The radio switches on at the actual volume it had when it was last switched off.
VOL DEFA: After pressing SEL button, AVOL will be displayed. Then you can pre-select a
constant switch-on volume by using the VOL knob.
9)CLK ON/OFF
CLK ON: Clock will always show on the display when power off.
CLK OFF: Clock will disappear on the display when power off.
3. LCD Display
4&5. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS
Press the >>| or |<< button shortly to manual tune up/down for the desired radio station frequency
step by step.
Press and hold the >>| or |<< button for longer 0.5 seconds, to automatically tune up/down for the
radio station frequency of strong signal.
6. BAND BUTTON
Press the BND button briefly to select the radio broadcasting band you would like to hear.
The AM/FM band is toggled cyclically through the tuning bands:
->FM 1-> FM 2 -> FM 3 -> MW 1->MW 2 ->.
7. POWER ON/OFF,MUTE BUTTON
When the unit is power off, the unit comes to ON by pressing any button on the front panel (except the
OPEN key ). It also can turn on the unit to insert a disc, SD card or USB stick into their slots or socket.
When the unit is power on, press and hold the power button, the unit goes into power off mode.
This button serves to switch the MUTED state on/off.
Press this button to suppress the loudspeaker temporarily, and press again to resume listening.
The muted state will be also released when the MODE, SEL button is pressed and VOL knob
on the front panel is used.
8. APS BUTTON (Auto-storage /Preset scan)
1) when long pressing for more than 1 seconds, the radio searches from the current frequency and
checks the signal strength level until 6 station are found. And then the 6 stations frequency are
preset to the corresponding preset memory numbered bank. The auto-storage operation is
implemented in the each selected band.
When the auto-storage operation is finished, the radio execute the Preset Scan.
2) when short pressing, the radio searches for each preset station in the current band and holds
at that preset number for 5 seconds with releasing mute, and then search again.